QF Manual Diverter 14 ga

Nordfab manufactures ducting for use in dust, mist, and fume collection systems.

Our 14 Gauge Manual Diverter Valves provide a high efficiency, economical method of diverting the flow of material or air.

Housing constructed of heavy duty 3/16” thick, painted black metal (carbon steel), with welded seams. Transitions constructed of 14 gauge galvanized steel. Supplied with heavy duty flange bearings and rubber seal in door.
Available with Quick-Fit™ (QF) rolled ends in sizes up to 24″ diameter or flanged ends. Flanged end is standard rotational Angle Flange retained via vanstone lip.
45º angle only.
Other sizes available upon request.
Reverse flow available upon request.
Available with flanged ends in diameters up to 24", and other various end types
Optional gauges 18, 16, and 12

Contact Nordfab or your local Nordfab dealer for assistance with material / end type options.

规格

A. General Fabrication Requirements: Comply with SMACNA's "HVAC Duct Construction Standards - Metal and Flexible," Ch. 3, "Round, Oval, and Flexible Duct," based on indicated static-pressure class unless otherwise indicated.
1. Construct ducts of galvanized sheet steel unless otherwise indicated.
2. Basis-of-Design Product: Subject to compliance with requirements, provide Nordfab Ducting, LLC; Quick Fit (QF) Duct.
B. Connection Joints: Joint types are fabricated in accordance with SMACNA's "HVAC Duct Construction Standards - Metal and Flexible," for static-pressure class, applicable sealing requirements, materials involved, duct-support intervals, and other provisions in SMACNA's "HVAC Duct Construction Standards - Metal and Flexible."
1. Quick Fit Joints in Ducts 3 to 24 inches (76 to 510 mm) in diameter. Flange: Optional.
2. Flanged Joints in All Ducts Greater than 24 inches (610 mm) in diameter.
C. Longitudinal Seams: Seam types are fabricated in accordance with SMACNA's "HVAC Duct Construction Standards - Metal and Flexible," Figure 3-2, "Round Duct Longitudinal Seams," for static-pressure class, applicable sealing requirements, materials involved, duct-support intervals, and other provisions in SMACNA's "HVAC Duct Construction Standards - Metal and Flexible."
1. Fabricated round ducts 3 to 24 inches (76 to 510 mm) in diameter to have laser-welded or plasma-welded longitudinal seams.
2. Fabricated round ducts above 24 inches (610 mm) in diameter to have plasma-welded longitudinal seams.