Публікуйте свої продукти
Snap-On Standing Seam metal roof panel
PAC-CLAD | Petersen

Snap-On Standing Seam metal roof panel

Features
  • Ideal for transition roofs
  • Herr-Voss corrective leveled
  • Stiffener beads available
  • 30 year non-prorated finish warranty
  • Maximum panel length of 45 feet

Snap-On panels are ideal for use in roofing, mansard and fascia applications. Snap-On panels are designed to be installed over a waterproofed solid substrate and a minimum 3:12 roof pitch. Snap-On panels are factory roll-formed in continuous lengths. Maximum panel length is 45’ and minimum panel length is 4’.

These panels are ideal for specification on applications where roof transitions are required. The simplicity of the pan design combined with corrective leveling provides superior flatness and allows for greater workability on site.

Trim

All flashing and trim shall be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032 – .063 gauge as specified) or PAC-CLAD steel (24 gauge or 22 gauge as specified). A 30-year non-prorated finish warranty can be supplied covering finish performance. Vinyl masking is recommended on all fabrication applications where extra handling is expected. NOTE: The strippable film must be removed immediately after installation.

Installation

Snap-On panels shall be installed over solid decking (5/8” plywood, nailboard insulation or equal) with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen Aluminum nonpenetrating clips, fastening on 18” centers (max.). Minimum slope at 3:12 pitch. Consult a local architect or engineer for requirements of local codes and conditions.

Curved Panels

The 1” high Snap-On standing seam panel can be curved to a concave or convex radius, with a minimum radius of 9’. This panel is ideal for barrel vaults and entrance ways. Curved panels must be installed over a waterproofed solid substrate.

Технічна специфікація
  • Унікальний номерroof-panel-pac-clad-snap-on-standing-seam
  • Сімейство продуктівRoof Panels
  • Група продуктівRoof Panels
  • ТипObject (single object)
  • Дата публікації2015-06-09
  • Номер видання1
Посилання
Пов'язані
  • Розроблено вUnited States
  • Виготовлено вUnited States
Класифікація
  • Категорія BIMobjectБудівництво - Дах
  • Класифікація IFCRoof
  • Назва UNSPSCRoofing materials
  • Код UNSPSC301515
  • Код Uniclass 2015Pr_25_93_72
  • Опис Uniclass 2015Roofing and cladding units
  • Код CSI MasterFormat 201407 40 00
  • Заголовок CSI MasterFormat 2014Roofing and Siding Panels
  • Номер OmniClass23-13 39 27
  • Заголовок OmniClassRoof Cladding

Доступність регіону

Північна Америка
United States