QF Long Radius Elbow

Nordfab manufactures ducting for use in dust, mist, and fume collection systems.

Quick-Fit^® Long Radius Elbows have rolled ends for use with Quick-Fit Clamps, allowing quick assembly / disassembly and relocation.

Long Radius Nordfab QF® elbows, also referred to as Bends, are available in 90°, 60°, 45°, and 30° with radiuses of 1.5 or 2.5. Standard elbows are also available with radiuses of 1.0 or 1.5.

Galvanized QF Elbows in sizes 3″-7″ are press formed halves stitch welded together. QF elbows in sizes 8″-24″ are segmented (gored). Stainless steel QF Elbows sizes 3″-6″ are tubed.

Elbows in heavier gauges can be supplied in solid welded construction at an additional cost. For highly abrasive applications or placement in a high wear area within the duct line, Nordfab long radius elbows in 14 gauge steel construction or 12 gauge may be the solution to reduce the frequency and cost of replacing worn-through elbows.

Available in Galvanized and 304SS (as shown below) or optional 316SS or carbon steel
Available with flanged ends in diameters up to 72", and other various end types
Optional gauges 20, 18, 16, 14, 12 and 10

Contact Nordfab or your local Nordfab dealer for assistance with larger sizes and material / gauge options.

Quick-Fit has been used in a wide variety of applications, wherever dust collection or fine particulate transfer is required. Quick-Fit saves time and money on installation, is easy to clean out, is adaptable to existing ductwork, and is easily re-used during shop floor reconfigurations. Learn more about why Quick-Fit may be the best solution for you.

Специфікація

A. General Fabrication Requirements: Comply with SMACNA's "HVAC Duct Construction Standards - Metal and Flexible," Ch. 3, "Round, Oval, and Flexible Duct," based on indicated static-pressure class unless otherwise indicated.
1. Construct ducts of galvanized sheet steel unless otherwise indicated. 304SS Optional.
2. Basis-of-Design Product: Subject to compliance with requirements, provide Nordfab Ducting, LLC; Quick Fit (QF) Duct.
B. Connection Joints: Joint types are fabricated in accordance with SMACNA's "HVAC Duct Construction Standards - Metal and Flexible," for static-pressure class, applicable sealing requirements, materials involved, duct-support intervals, and other provisions in SMACNA's "HVAC Duct Construction Standards - Metal and Flexible."
1. Quick Fit Joints in Ducts 3 to 24 inches (76 to 510 mm) in diameter. Flange: Optional.
2. Flanged Joints in All Ducts Greater than 24 inches (610 mm) in diameter.
C. Longitudinal Seams: Seam types are fabricated in accordance with SMACNA's "HVAC Duct Construction Standards - Metal and Flexible," Figure 3-2, "Round Duct Longitudinal Seams," for static-pressure class, applicable sealing requirements, materials involved, duct-support intervals, and other provisions in SMACNA's "HVAC Duct Construction Standards - Metal and Flexible."
1. Fabricated round ducts 3 to 24 inches (76 to 510 mm) in diameter to have laser-welded or plasma-welded longitudinal seams.
2. Fabricated round ducts above 24 inches (610 mm) in diameter to have plasma-welded longitudinal seams.