Pull-Through System
- Pull-through system — the products of combustion are pulled through the combustion chamber for increased radiant efficiency and greater safety
- CSA design certified for vertical or horizontal venting
- CSA design certified for maximum 75 ft. horizontal sidewall venting
- 4″ O.D. flue connection for LTU40-LTU175; 6″ for LTU180-LTU250
- Draft inducer is equipped with permanently lubricated, totally enclosed, fan cooled and heavy duty ball bearing motor for maintenance-free operation
- Draft inducer assembly can be used for through-the-roof venting or rotated 45 degrees or 90 degrees for horizontal venting
- No draft hoods, totally enclosed combustion chamber
- CSA design certified for vented or indirect vented operation.
Burner & Control Systems
- 3 Monitoring light system for on line diagnosis- power on, insufficient air flow, and ignition sytem operation
- Monitoring light system for on-line diagnosis
- One-piece cast iron burner with stainless steel flame retainer
- 10 year limited warranty on burner
- Inside or optional outside air for combustion
- CSA design certified for 50 ft. fresh air inlet duct
- 4″ or 6″ O.D. standard fresh air inlet duct opening for LTS40 – LTS75; 6″ for LTS80 – LTS250
- Burner inspection sight glass
- State-of-the-art redundant, step opening, combination gas valve for quiet ignition and added safety
- Diaphragm Air Proving Switch–a safety device for proof of venting before gas flow and ignition
- Direct Spark ignition system with 100% Gas Shut-Off Safety Control (30 second pre-purge)
- Quick slip-on electrical connectors and quick 115-volt terminal block connection
- Uncomplicated maintenance access
- 36″ Stainless Steel flexible gas connector included with control box
Radiant Emitter Tube System
- All radiant emitter tubes are 16 gauge, 4″ O.D. calorized steel
- Body assembly consists of 5′ and 10′ body sections that can be assembled in desired configuration (elbows and corner reflectors are optional)
- Titanium alloy Alumi-Therm and aluminized steel emitter tubes are calorized for long life and high radiant efficiency — will not flake or peel, and are corrosion resistant
- The calorization process (PDF) produces an emitter tube which is highly radiant absorptive on the interior and highly radiant emissive on the exterior
- Suitable for horizontal or angle mount up to 45 degrees
- CSA design certified for incline mounting up to 2/12 pitch roof structure
- 5 year limited warranty on the emitter tube
Reflector System
- Fully factory pre-assembled on tube body to minimize field assembly and save installation labor cost
- Highly efficient aluminum reflectors with reflectivity rating of 97%
- Reflector ends are enclosed for maximum radiant heat output and minimum convection loss
- Easy-to-use mounting brackets
Other
- Quick 115 volt terminal block connection
- 1/2″ MPT gas inlet connection
- CSA approved for direct vented or indirect vented operation
- Optional deflector kit for reduced clearances to combustible materials
- Optional decorative grille kit for drop ceiling applications
- Optional side reflector kits
- CSA Certified according to ANSI Z83.20 and CSA 2.34. NOT Certified for Residential Use
Keywords: outdoor heater, commercial heater, infrared heater, infrared heaters, space heater, restaurant heater, hospitality heater, patio heater, patio heaters, garage heater, industrial heater, infrared heater, outdoor infrared heater
4.6 
