Crestron Electronics Inc.Følg

DM-RMC-4K-100-C-1G - Wall Plate 4K DigitalMedia 8G+® Receiver & Room Controller 100

Specifikation

Specifikation

• Summary Of Features Cost-effective DigitalMedia 8G+® receiver and display controller Connects to a DM® switcher or transmitter over a single CAT type twisted pair cable [1,2] HDBaseT® Certified — Enables direct connection to other HDBaseT certified equipment Provides one HDMI® or DVI display output [4] Handles video resolutions up to 4K and Ultra HD Handles 3D video and Deep Color Handles Dolby® TrueHD, Dolby Atmos®, DTS-HD®, and uncompressed 7.1 linear PCM audio HDCP 2.2 compliant Supports cable lengths up to 330 ft (100 m) for all resolutions up to UHD and 4K using DM Ultra cable [2] Supports cable lengths up to 330 ft (100 m) for 1080p, WUXGA, and 2K using DM 8G® cable or CAT5e [2] Supports cable lengths up to 230 ft (70 m) for UHD and 4K using DM 8G cable, or 165 ft (50 m) using CAT5e [2] Enables device control via CEC, IR, and RS-232 [1,7] Powered via the DM connection or local power pack (included) [5,6] 1-gang wall box mount design (3-1/2" deep) Surface mount bracket included Available in white or black finish Notes: 1. The IR and RS-232 (COM) ports are only enabled when the DM-RMC-4K-100-C-1G is connected to an Ethernet-enabled DM transmitter or switcher that is addressable from a Crestron control system. When connected to a DM switcher, the switcher must be in private network mode. 2. The maximum cable length for DigitalMedia 8G+ (DM 8G+) or HDBaseT is dependent upon the type of cable and resolution of the video signal. Refer to the “Maximum Cable Lengths” table for a detailed overview. Crestron legacy cable models DM-CBL DigitalMedia Cable and DM-CBL-D DigitalMedia D Cable support the same resolutions and cable lengths as CAT5e. Shielded cable and connectors are recommended to safeguard against unpredictable environmental electrical noise which may impact performance at resolutions above 1080p. Refer to the Crestron DigitalMedia Design Guide, Doc. #4546 for complete system design guidelines. DM 8G+ is compatible with HDBaseT Alliance specifications for connecting to HDBaseT compliant equipment. All wire and cables are sold separately. 4. The HDMI output requires an appropriate adapter or interface cable to accommodate a DVI signal. CBL-HD-DVI interface cables are available separately. 5. To power the DM-RMC-4K-100-C-1G using PoDM (Power over DigitalMedia) requires connection to a DM switcher or other equipment that has a PoDM PSE port. Any wiring that is connected to a PoDM PSE port is for intra-building use only and should not be connected to a line that runs outside of the building in which the PSE is located. 6. To power the DM-RMC-4K-100-C-1G using HDBaseT PoE requires connection to a switcher or other equipment that has an HDBaseT PoE PSE port. Any wiring that is connected to an HDBaseT PoE PSE port is for intra-building use only and should not be connected to a line that runs outside of the building in which the PSE is located. 7. Supports simple pass-through of CEC when connected directly to a DM-TX-4K-100-C-1G transmitter. Supports full management of CEC between the locally connected HDMI device and a control system when connected to an Ethernet-enabled 4K DM transmitter or switcher that supports CEC over HDBaseT. Refer to the spec sheet for each DM transmitter, switcher, output card, or output blade to verify “CEC” is listed under “HDBaseT” in the “Communications” section of the product’s specifications.

Teknisk specifikation

Teknisk specifikation

• Unik ref.DigitalMedia_Receiver_DM-RMC-4K-100-C-1G
• ProduktfamilieVideo
• ProduktgruppeDigitalMedia Endpoints
• TypeObjekt (enkelt objekt)
• Udgivelsesdato2017-04-17
• Udgavenummer1
• Højde (tommer)4.12
• Bredde (tommer)1.72
• Dybde (tommer)2.35

Links

Links

• Produkt-URLhttps://www.crestron.com/products/model/DM-RMC-4K-100-C-1G
• Teknisk beskrivelsehttps://www.crestron.com/downloads/pdf/spec_sheets/commercial_and_residential/dm-rmc-4k-100-c-1g.pdf

Relateret

Relateret

• Materiale primærtMetal
• Materiale sekundærtPolycarbonat
• Designet iUSA
• Fremstillet iUSA
• Nettovægt (lbs)0.394

Klassifikation

Klassifikation

• BIMobject-kategoriElektronik - Kommunikation
• Uniclass 2015-kodeEF_75
• Uniclass 2015-beskrivelseCommunications, security, safety and protection functions
• CSI MasterFormat 2014-kode27 20 00
• CSI MasterFormat 2014-titelData Communications
• OmniClass-nummer23-37 00 00
• OmniClass-betegnelseInformation and Communication Specific Products and Equipment